Posts

Chosen Solution Why is the fan making noise and not working? NOTE: Hard drive noise may be misinterpreted as fan noise. Evaluate the location of the noise. Remove media from the CD/DVD/BD drive. Press the Fn key and the F2 key to mute the sound and determine if the noise is speaker related. Check all the fan vents to see if the noise is louder from any of those locations. NOTE: The locations of the fan vents will vary depending on the model....

Chosen Solution i have a toshiba sattelite with a strange keyboard when i press a key with two options (FN -normal) it it only does the FN but i didnt press fn and when i press FN i get the normal options If your saying when you press fn it does normal but when you dont it does fn? if thats teh case thats normal. Nothing strange there. Just something that different between manufactures....

Chosen Solution Hey everyone. I recently found my old iPod Classic from about 10 years ago at least. I plugged it in after searching for an old 30-pin charger and to my surprise, it actually the “Charging Battery” icon. However, after about 10 minutes of charging, it goes to the Apple logo and than does nothing. I’ve tried resetting it, but it doesn’t even reboot, it just stays at the Apple Logo as if I’m not even touching any buttons....

Chosen Solution My game volume button does not work anymore. The volume is stuck on high Vincent Mohan I believe this to be a round “button. Sounds like the potentiometer is broken. Disassemble the case and post some images of what you find with your question. We may be able to guide you to a replacement and/or the repair of it. Adding images to an existing question

Chosen Solution the noise started after being over loaded is worse or louder during spin cycle Clutch If the washer is making a loud noise in the spin cycle, the clutch assembly might be worn out. The clutch assembly makes the connection between the transmission and the inner tub. It is designed to allow the tub to get up to the proper spin speed gradually. As the clutch wears out it may become loud during spin or just after the spin cycle finishes....

Chosen Solution HeroPlus Damage Case The case is a fixed piece on the hero series cameras. If it broke and its within a year gopro should replace it without much hesitation. Outside of that you will have to go back to gopro as there are no aftermarket cases for it.

Chosen Solution I think I have a virus. I try to make msn my homepage and I keep getting an unsecured page that is nearly blank except for a header with tabs about plane flight arrivals, etc. Most likely a browser hijacker. Try to download malware bytes, it is free and do a scan. It should pick up the problems and give you a solution. Failing that; Try This or This....

Chosen Solution Canon Pixma ip8750 printer won’t turn on, no lights or power. Power supply unit changed but still no power. All cables checked, just no power to the printer. Any help much appreciated Hi @hatchet, This sounds like you have either a faulty power switch, or possibly a broken power board. I’d start by checking the power switch for continuity (you’ll have to start opening the printer). Unfortunately there’s not a whole lot of information about this printer online, and I’ve never worked on one personally, so I’d start carefully and meticulously taking it apart to get at both the switch and the power board inside....

Chosen Solution I’m assuming I can diagnose and repair this camera without a lens attached. Canon EOS Rebel T3i was dropped. When I insert an SD for the first time, the camera creates the DCIM\EOSMISC directory and creates the M0100.ctg file inside it. The screen generates a backlight, but no image. Pressing Menu (and perhaps the Info) button seems to toggle the backlighting (and/or image). The screen actually looks intact - I fail to see cracks....

Chosen Solution Is it possible to change the ram from 4 to 8 GB? Because its written at the spesifications for this model thats its max. ram upgrade is 8 GB? Where is the connection for where I can change it? I can´t find it. Hello, The RAM is soldered on the motherboard. You can not upgrade. I dont know by 100% but afaik the RAM is soldered onto the mainboard....

Chosen Solution Why won’t my tablet come on or charge? Maybe the battery has gone bad. Do you have another tablet like that, which works? If so then try taking the battery (if possible) out of the tablet that isn’t coming on or charging and put the battery which is in the working tablet into the other tablet, if it works then you know the battery has gone bad. (make sense?...

Chosen Solution Not used since 2016. Charged it (May not be original cables). The brand comes up on screen, plays a tune with animation, and then brand just stays on screen. Tried holding power button for 20 sec. Screen goes blank for a few seconds, then back to the brand screen again. Any suggestions? Sounds like your device is going into a boot loop stage. Because of this, you may have to perform a factory reset or clear the cache partition, both being done in the recovery menu....

Chosen Solution Hello guys! I bought a 2001 clio 1.2 16v last week, and since then i’ve been noticing 3 problems. I need to change a cv axle, and the valve cover gasket that is leaking to the heatshield burning oil, And there’s the weird noise. It’s like a crackling sound, it comes from the left side of the engine and its getting worse (when i got it, it started at about 1,5k rpm the noise, and noise at 1k) and im afraid that it’s just not a annoying sound, but something serious....

Chosen Solution Need the location of the crank sensor on a 2007 3.3 liter all wheel drive Hyundai Santa Fe @robfish its located behind the starter and you’ll have to reach it from under the car.

Chosen Solution hello everyone! i have dead iphone 5 but it recognized when i conected to itunes on notebook -it no sound indicator when i charge it but it warm that indicate the battery was charged no vibrate when i slide the silent switch button -i already replace with new lcd screen but still same -i try restored in DFU mode with itunes, and succesfully restored but nothing happens, the phone still dead for the last, the battery drain fast in stanby before it was dead from 80% in the night to 20% in the morning maybe it have serious problem on hardaware like ic cpu or another?...

Chosen Solution I have zenfone 450 CG and it is not start up. It is continue in boot mode. What can I do? Try booting while the device is charging. If the problem disappears, that means your battery is faulty. If the problem continues, there any many places to look at. First of all, there might be a problem with software, (if your tried rooting in the past). Other things might be the cpu or even the controller chip related to the sim....

Chosen Solution I replaced the battery and while opening up the screen, I tore off the wifi antennas from its assembly. However, the wifi still works after putting it back together. The one thing I am confused about is, on this model, the antenna do not connect to anything on the motherboard, or am I mistaken? There is a little metal piece on the bottom of the assembly (3rd pic) which connects to the motherboard but that piece does not attach to the antenna whatsoever....

Chosen Solution I recently dropped my Samsung Galaxy SM-A520W 2017 phone face down and now have a screen covered with hairline cracks does not appear to affect the screen itself do I have to replace the whole screen or can I just replace a tempered Glass lens? I got a quote for $230 at a phone repair place and I’m wondering is this really necessary to replace the entire screen? and if I can just replace a lens where can I get one for this model....

Chosen Solution I purchased a used iPhone 7 and replaced the cracked screen with a new one. It is in cosmetically almost mint condition now (housing was in very good condition), however have noticed that when 20Watt fast charging it and during use it can get quite hot near the logic board. The device hasn’t been water damaged (indicator is white) and the logic board is in visibly perfect condition with no signs of logic board repairs, and all parts appear to be Apple Original....

Chosen Solution Phone randomly shuts down, reporting that it overheated. Phone doesn’t get hot to the touch. I’ve removed most apps. Likely it is a faulty temperature sensor inside of the phone. Try replacing the wireless charging module and seeing if anything changes.