Chosen Solution I’m trying to replace the back housing for my iphone 6s. Do I have to transfer all the small foam pads onto the new back housing? Will it be a problem if I don’t transfer the foam pads? It would be needed, highly advisable as it will stop the logic board from touching the bare metal and stop it shorting out thus leaving the phone useless and damaged....
Chosen Solution The 4th gen digitizer KIT says it has a “blank home button.” Does that mean it comes with a new home button or do I need a new one? The screen is cracked and the home button isn’t working. Hi @acm1023 “Blank” home button simply means that it won’t contain the square design like the original button. It will work perfectly as intended. You can swap the “blank” home button for your original off the old screen to keep the original look if needed....
Chosen Solution I repair a few iPads and occasionally rip the wifi-bluetooth cable. So far when repairing the iPad 3’s I haven’t ripped any yet, but I was wondering if an iPad 2 part would work in a 3. I know the iPad 3 has bluetooth 4 but I think that’s all controlled at the board? Anyone know? No. The 2 parts have different Apple Part Numbers (APN) and they have different brackets where it is screwed into place....
Chosen Solution I’m having problems with my Dualshock 4 controller. If it’s not plugged in with the USB cable, it does nothing. No lights when I press the PS button. When I turn on the console, it says connect the controller with the USB cable and press the PS button. When I do that, nothing happens. No lights on the controller and no response from the PS4. However, when I turn on the console in safe mode, the controller seems to work just fine....
Chosen Solution The engine runs sluggish until I engage the blade then it runs fine , once i disengage the blade it runs poorly again What is the model number? Sounds like the blade brake is not working. most of the lawn mowers I work on stops the engine when blade lever released.
Chosen Solution Hello everyone, I just changed my hard drive with a new one which is a SSD “samsung EVO 850 EVO”. It works well and I can write this message with my mac without problem. The only one is when I’m copying more than one file on my computer from an external disk. The error -36 is displayed and I need to copy each file one by one (and sometimes it doesn’t work)....
Chosen Solution Cannot dowload app cannot setup google when reboot and my system cannot download and storage memory and apps size all show o only try to remove some apps to empty the memory apple iphone 6 plus galaxy s6
Chosen Solution Hi there! I have a LG G2 phone with Android 5.0.2 and theres a problem with that. the problem is every time I power off the phone , any preference goes away. for example my date and time resets to a random day, my phone name resets, my hotspots name, some of my Apps loose their data. I couldn’t find anything wrong with my phone and I dont know what should I do!...
Chosen Solution I want to connect external Apple iSight cammera to my MBP (early 2015) via Apple Thunderbolt-Firewire adapter. Has anyone successfully tried this? I guess it’s supposed to work, but I’d like to check before buying the adapter. I read in some cases the adapter doesn’t recognise the camera. I’ve got one hooked up to my 2008 Mac Pro using a Firewire 400 to 800 but have not tried it using Thunderbolt to firewire adapter....
Chosen Solution I have a Frigidaire front load washer.. and every load where I use softner.. all three dispensers.. dispense at once.. Detergent.. Bleach and Fabric Softner.. Is this normal ? Do clothes get cleaned properly ? I thought the Softner would dispense in rinse cycle ? Thanks for your input ! This is not normal. You are correct that fabric softener should be added at the spin/rinse cycle. Without knowing your exact model number, it would be difficult to troubleshoot - which could involve replacing the dispenser tray, the water inlet valves, or the control board....
Chosen Solution I tried change batteries and hard reset. But that not help. The furby is paralyzed meaning the small 6V brushless DC motor went wrong. I had the same issue. You can replace it with one from a PC DVD reader (this is the door opener motor). Shaft is smaller but it’s ok, diameter is good. You need a solder iron as well to replace electronic part from DC motor....
Chosen Solution Replaced boards , evap fan, and both door switched. Defrost heater won’t come on Cause 1 The Evaporator Coils are Frosted Over The defrost heater assembly turns on a few times throughout the day to melt away any frost that may have accumulated on the evaporator coils. If the defrost heater assembly is defective, frost will continue to accumulate on the evaporator coils, and the coils will become plugged with frost....
Chosen Solution some of the keys barely work on mine i have tried using compressed air to clean underneath them but it didn’t work so i want to try taking them off to clean the connectors but i don’t know if the keys can be put back on Hi, I’m not familiar with your model but it looks like you can as you can get individual replacement keys (supplier example only) for the laptop....
Chosen Solution I have a 03 lexus rx300 and I replaced the battery and the starter why Turn the key on all lights light up but when I try to start it all go dim and just Hi, Here’s the 2000 Lexus RX 300 Service Repair Manual and Wiring Diagram. I realize that you said that it was a 2003 model but hopefully they may be the same as far as starting the vehicle is concerned....
Chosen Solution Hello, first timer here. I have a Macbook Pro Retina, late 2013. I checked around and found out my screen A1398 (EMC 2674) .. and I have found some screens that are late 2013, 15” but the EMC is 2745. Would that screen work on my Mac? I followed the guide and took off my broken screen already. Any help would be appreciated. Clearly this version displays have lot of problems....
Chosen Solution There are no blue lights on the charging unit when I put my vacuum in to charge. I’ve checked the power cord and it seems ok. There are usually two answers to faulty rechargeable items - battery and related charging circuitry, the charging unit. The easiest check if familiar with a multimeter or digital voltmeter would be measuring the charger itself. Most chargers are plug-in units like cellphone chargers while others have a mounting base with the charging unit within it and having two chrome plated pins, a male/female connection for power or small metal plates....
Chosen Solution Every single time I do a simple screen replacement on iPhone SE, I turn it back on and it stays at 1%. That’s it. Before repair, charging normal. After repair, doesn’t charge at all and stays at 1%. This has happened 8/8 times. I’ve come across this issue 3 times in the last week, and there’s one point in common with all 3 devices : missing small components next to the battery connector on the motherboard (see image)....
Chosen Solution My glass has a hair line crack, display works, can I replace my series 3 glass with series 2 glass? Just the glass not the LCD Can’t replace the crystal alone as the OLED screen is glued to it. You’ll need to replace the complete assembly.
Chosen Solution I am looking to recover my pictures off my old S7. The LCD broke and caused the screen to be consumed by a purple black color before becoming all black and useless. I can’t unlock it and therefore can’t access files then I plug it into my computer. Is there an other way I can get my pictures without repairing the whole phone? Have you tried attaching a keyboard via usb that might let you enter your....
Chosen Solution When the red/green light didn’t work I replaced the DC in Board, but the new DC in Board still has no light. What is wrong with my beloved Mid 2010 Macbook Pro Laptop? Thanks Rob Well at this point we will need to assume the charger is bad. As unless we have a known good charger we have no start point to work from. You’ll need to either find a friend with the same wattage charger or you’ll need to get a new one....
