Posts

Chosen Solution So, i replaced my screen and housing (and battery) of my iPhone 7. But when i tried to turn it on it shows the apple logo and nothing more.. it keeps showing the Apple logo. DFU mode doesnt work, neither does it get recognized by iTunes… when i click the home button i hear a click in the speaker but the taptic engine doesnt give me feedback.. i tried replacing the taptic engine as well as the dock connector, but that didn’t help so far…...

Chosen Solution Can ethernet port be damage by defect rj45 cable ? Tried new selvmade rj45 cable with no success and ethernet port thereafter not working any rj45 cables (which I know is ok). Have tried Reset NVRAM and disconnect and shutdown scenarios - no success. Can run wifi but need the better LAN bandwidth, not any way resolved my LAN port ? Many regards Macmini6,2, Intel Core i7, 16GB Ram...

Chosen Solution Why will everything on my microwave work but will not heat food? Good question! But if it’s not heating food, then your Magnotron is probably broken. On a less expensive side, maybe a another part that powers the Magnotron is fried. Though since microwaves are very sensitive and can cause some pretty bad bodily harm if repaired wrong, I suggest you just get a new one. the magnetron takes electricity from the power outlet and converts it into high-powered, 12cm (4....

Chosen Solution so I upgraded the SSD on my Macbook air and ever since then the fan is non stop spinning. I have cleaned out the fan after completely removing it, reset the SMC and NVRAM not no change. the air blowing out is cool so the Mac isn’t over heating. Any help would be great! Let’s seee if we can isolate the problem first. Please re-install your original SSD and let us know if the problem persists....

Chosen Solution Whenever I put in a new pack of film usually the first shot will get jammed , usually a gentle tap on the side or reinserting the pack works but I always lose that first shot, any advice/help ? This problem may be caused by a small amount of misalignment in the camera. It concerns a part called “pick” which ist visibly when peering into an empty camera before inserting film....

Chosen Solution I haven’t used my calculator since the AP Calc test, so I don’t know specifically when it happened, but now when I turn it on, I can’t do anything. At first the screen just flashed “Ans^-1” (but the actual display of power of negative one) over and over, like I had selected it, but no matter what button I hit, nothing happened. I pulled out the batteries a couple times, waited half an hour, but nothing changed....

Chosen Solution The front camera on an iPhone 4s does not work. I have tried replacing the physical camera already, so the issue is likely with the logic board. I found some instructions on how to fix this, shown below. Can anyone confirm that they are correct? Yes it will work I have done it

Chosen Solution Were is the fuel pump relay located on this Ram 1500 4.7L v8 flex fuel? and just in case all the legend of the fuse box if someone have? @jcrafaga should be number 58 in the IPM under the hood

Chosen Solution screen stopped working after battery unplugged and re plugged to stop a random shutdown reboot that happened every short while the screen is now not on any ideas? thanks Reconnect the LCD cable connection to the main board. Was probably knocked loose during the battery re-connection process.

Chosen Solution Went to get phone from charger and it was froozing. Now I can’t turn it off or on. Now what? The best thing to do is to try your best to turn off the power of your phone completely and let it sit for a while then turn it on. If your phone was overheating to that might be the reason of the freezeing for to many apps my have been open in the backround of your device....

Chosen Solution I am a retailer and have just contracted with the local school board to do repairs for their devices. Today I was handed two HP elitebook revolve 810 g1"s that need screen replacement. How do I change out the screens Hi @tcope , Here’s a link to the service manual forthe laptop. Scroll to p.61 to view the necessary pre-requisite steps and then the procedure to remove the display panel....

Chosen Solution I recently bought this tiny chip, but I’m not sure if they are the same, for the numbers change. My original chip is pxd 843 and the one I recieved is pxd 031. Are they doing the same job? No matter those numbers? Angie Palomino we really would have to see what you got there or at least where it sits on your board. Post some good pictures of the part and it’s location on the motherboard....

Chosen Solution i dropped my controller in water for no longer than 5 seconds, i have taken it apart and left it apart to dry out, should it be okay to use after being put back together? HI @mcgabz , Have you disconnected the battery in the controller while you are waiting for it to dry? If not you may want to check if any corrosion has started to occur. Water and electronics and electricity are not a good mix....

Chosen Solution I have a 2004 Pontiac Grand AM that cranks but does not start. We have replaced the fuel filter, fuel pump, fuel regulator, and fuel pump switch but it still does not start. Can you send me any more advise???????? Get your car scanned for codes first off. Always do that before replacing anything. I’d bet though it is probably your crank angle sensor, but get it scanned first....

Chosen Solution Hello, I got a Sony Trinitron KV-21CL10B for retro gaming (EU-PAL mostly). I noticed that the white balance changes according to the image on the screen and colors are off according to the prevalent color on screen. Let’s say I’m playing Super Mario 64 and there’s lot of grass in the the screen, everything looks green-ish, if I move where water/sky is in sight everything looks blue-ish, same if red colors are prevalent on screen....

Chosen Solution Hello! I recently picked this up at a thrift shop since I have always wanted to try one. I’ve used it 7 or 8 times and the last couple times the paddle would stop spinning to mix the ingredients. I thought it was due to gunk on the paddle or the inner container wasn’t inserted properly. This last time it mixed maybe two times and then would have an audible “click” sound instead of turning the paddle....

Chosen Solution Hi, i’m doing a SSD upgrade for a customer soon and saw some guides detailing people inserting a OWC sensor cable in their imacs. I was planning on going ahead of the upgrade but not installing this component. Would i need this part? It didn’t come with the imac and there should be temprature sensors within the imac itself right? I had someone tell me it would be fine without it and i had someone else tell me the fan would run at 100% all the time if i didn’t install it....

Chosen Solution Hi, everyone! I was using my MBP 2010 booting from an external drive cause the HDD cable was broken, then two days ago I replaced the cable and now it doesn’t boot. Everything makes noise running, but after 5sec the MPB turn off and then turn on again and continuing until I press SHIFT+CTRL+OPTION+POWER to turn it off. I made a record: https://youtu.be/iocJlE1y-go Can anyone help me, please?...

Chosen Solution Is there a way to force the iPhone to charge. It will not power on or get recognized by iTunes while plugged in via the lightning cable. I’ve ruled out the lightning cables, iTunes software and power outlets. I’ve also cleaned the lightning port using a new unused toothbrush. Hi Nick, this sounds like the case of either a bad battery or a failed Lightning port. I would recommend that you try a new battery....

Chosen Solution Samsung Galaxy S does not recognise any sim card. Previous sim card got stuck & now maybe area has been damaged. Any advise? Is this a new sim card ? not all sim cards work on phones , check with your phone co. or go on line to see what sim card you need