Posts

Chosen Solution I’m having problems with my Dualshock 4 controller. When connected to the pc via cable it works perfectly. When I try to play with it on PS4, with cable, it works for a few seconds and simply turns off the controller. Sometimes, before he hangs up, he goes crazy, pressing L2 forever and turning the analog ones to the sides. But it is rare. I tested it on DS4Windowns and it always shows as 0% Battery, even if you put batteries from other controls that are working....

Chosen Solution My fingerprint not work so i open the phone and got one connector pin is broken , how can i solve that , thanks for your answer :) That picture is useless. You’ll have to remove the screws and the panel to expose the board properly to see if it’s a pin that’s missing or not.

Chosen Solution I have a 1ST Gen LG Stylo and when I turn it on it starts to boot up and then the metro PCS ball roll across the screen then just stays and freezes up at that stage. I have taken the battery out of the phone and left it out for a good while and when I put it back in the phone it still just goes to that same boot up screen, the screen with the metro ball rolling by and freezes up in that same place every time....

Chosen Solution Hi! I have a commercial refrigerator in my restaurant, the fridge has no brand. It is a 4 door, stainless steel commercial fridge which runs at around 3 degrees. For the past 6 months, the fridge has been warming up, it goes from the standard 3 degrees celsius to around 15-20 degrees celsius. When we call the technicians, they say that it could be a gas leak but they are never able to find a gas leak....

Chosen Solution Our freezer is a a Frigidaire Upright LFFH20F3QM0. The freezer “pan” is not accessible from the front, but is a curved container attached to the front side of the compressor with the only access from the rear. Compressor is easily accessible, but the container pan is on the front (!!!) side of compressor and not accessible. It does not seem to be removable and cleaning means reaching around and sopping out the gook with a rag or whatever....

Chosen Solution Hello everybody. This is my first question on this site, so please try to help me. I have changed iphone 6 housing with new one, the MB was working 100% before the replacement, and now i have gut a problem with the rear and front camera and flash light they don’t work!!!! I have checked everything on MB, Camera’s, flex cables, components, I tried all kind of restores, even new framwear....

Chosen Solution Cracked my screen, went and got it fixed at a local phone repair shop. Having issues when for example scrolling down facebook, or any up and down swipe motions. Really unresponsive and kinda jumps around when it does register the touch. Is this the fault of the repair shop? And should they take it back and fix it? Thanks Definitely it is an after-repair issue. Sometimes when technicians use wrong glue to mount new screen (it get’s hard as stone instead act like rubber)....

Chosen Solution My laptop was closed and suddenly the start up sound chimed and now the progress bar gets stuck at the halfway mark for hours on end. I DO NOT have auto updates I’ve tried Resetting NVRAM, same result thing progress bar only goes to halfwayResetting SMS, same results, slow boot stuck at halfwayCan not get to safe mode, the bar gets stuckCan not get into recovery or disk utility, I cannot get access to anything pass the boot up bar!...

Chosen Solution My touchpad is not scrolling and is not of the best quality. I have installed drivers but it still cannot scroll downwards when I use two fingers. Is there any way to replace the touchpad? Hi @yeetusboiryan , You should be able to but the hard part might be in finding a replacement part. Here’s a video that shows how to replace the keyboard in a MSI GE62VR laptop....

Chosen Solution i take pitcures and cant view them Sounds Like your DCM file is corrupt. If your device is jailbroken a simple SSH and deletion of this file would do, but if not only a restore can resolve this issue if it’s software related. Have you dropped the phone? Anyway possible its hardware related? If not, then backup and restore your phone.

Chosen Solution Hi guys, Recently, I replaced some LCDs for our customers,I recognized that the rate customers came back to our store and complained about their Iphone keep restarting again and again. Even with customers changed their LCD very long ago, the phones acted the same way. The machines keep rebooting and some stuck on Apple logo. I have switched several vendors, but it still acted on that way. But when I put on OEM screen or OEM refurbished, it works like normally....

Chosen Solution iMac A1207 late 2006 Unplugged my computer from the wall last night because of potential lightning strikes. When I tried to start it this morning, it won’t turn on. When you take the frame off, please tell us the status of the diagnostic LEDs to the right of the RAM slots. Also what they do when you attempt a power on. It’s probably about time to replace the PRAM battery....

Chosen Solution Hello, I have an old iPod 4rd gen which i want to reactivate, because it fully works. The problem is that i had an old PC with firewire slot and now i have only Mac Book Pro from 2015 that has only USB and Thunderbolt slots. Also, iTunes sends a message like “Cannot connect your iPod with USB cable, please connect it over Firewire”. Is there a way to connect the aforementioned iPod with this Mac?...

Chosen Solution How to data transfer from vivo 5R to pc through USB cable? Connect it to your PC. Then, once you have done that go into the notifications section on your phone. You’ll see something about the USB connection in the form of a notification. Tap it and pick the setting File Transfer. To transfer data from vivo 5R to pc through USB cable, try Coolmuster Android Assistant. First, link it to pc via USB cable, enable USB debuggingg on it....

Chosen Solution Hello! So, recently, after binge watching DankPods for a full week, I decided to go and try out a repair on an iPod myself! I bought a 4GB iPod Mini 1st gen, for just £2.20 delivered. Not a bad deal! So far, I’ve managed to take it apart and give it all a look over. The issues I’ve seen are: Bloated battery One tiny resistor has fallen off the board Touch wheel is loose....

Chosen Solution hey guys. i do charging port replacements on a regular basis. i have soldered on all models of phones dating back to the BB9900, so i can tell you after 3 ports, that it is not the port failing. I have also ordered and replaced the battery resulting in the same failure. i have scoured the board under a 10X microscope, and find no physical damage to board, or related components The device says its charging, however, the % does not go up within an hour....

Chosen Solution Hi all, I replaced the battery in my 2017 MBP 15 yesterday and now the system runs the fans at max and the CPU is used in excess of 500% by kernel_task. As per a different post here on iFixIt I loaded TG Pro which indicates a possible fault with the hard drive temperature sensor. This sensor is not serviceable except with a logic board replacement. I’ve already purchased a replacement PC complete....

Chosen Solution When the battery level reaches about 50% the touch of the digitiser stops working… Sounds like the problem is more with the digitizer than the battery. Just a couple of questions: Did both problems showed up at the same time or separate? About how long have you had the problem? How long have you had the phone for?

Chosen Solution I am going to change my lithium battery on mid-2012 Mac book pro. Some websites suggest draining the battery for safety reasons. Some instructions also recommend that I shut down the computer all the way before changing the battery. I am trying to think about how I could accomplish both or these things. If I leave it on it will drain but the OS wasn’t put to sleep properly, whereas if I put the computer to sleep it won’t drain the battery....

Chosen Solution So i was putting phone in pocket and managed to miss pocket. Phone dont turn on at all. Phone looks untouched. Nothing broke as case protected it, not even a scratch. When i connect to power no Led turns on. Was thinking it was the screen but i connected it to the computer to see if usb would recognize with the beep computer does when it attaches something but nothing....